The total width of the high-pressure steel wire braided rubber hose strip is lower than the basic theoretical total width, and the actual value depends on the covering surface of the plastic mesh bag on the high-pressure rubber hose. The general weaving angle is 30-45. After determining other main parameters, in order to better ensure the installation capacity of the high-pressure hose, the weaving angle can be moderately reduced.

The ratio of plastic mesh bags to high-pressure rubber hose coverage is generally controlled within the overall planning range of 75-95. If the value is large, it will suppress the softness of the high-pressure hose. If the value is too small, it will not be able to maintain the high-pressure steel wire braided rubber hose from damage caused by mechanical equipment such as knocking, collision, grinding, and impact. Its size directly endangers the function of high-pressure rubber hoses, and its significance is exactly opposite to the weaving perspective. If the limit value is taken, the high-pressure hose can withstand higher loads, but it is not conducive to improving its flexibility. If the limit value is taken out, it is beneficial to promote its softness, but it cannot withstand higher loads.

Transportation and storage of rubber hose assembly

1. The storage period of high and low pressure hose joints or high pressure hose joint components should be short. If long-term storage is unavoidable, the product should be regularly inspected and tested before use.

2. When storing high and low pressure hoses or hose components, especially for long-term storage, storage standards should provide better maintenance and reduce damage to high and low pressure hoses or hose components.

3. Always pay attention to the movement of high and low pressure hose joints, and do not drag them on sharp and uneven surfaces, nor should there be any warping or flattening.

There are two types of high-pressure steel wire braided rubber hose joints, one requires peeling the outer rubber, and the other does not require peeling the outer rubber. Due to different joints, the groove of the joint head of the high-pressure hose that needs to peel off the outer adhesive should not be too sharp, otherwise it will damage the raised layer of the hose. Correctly pressing the connector is particularly important for the safety of high and low pressure hose joints and normal operation. There are various types of high and low pressure hose joints, and it is necessary to choose the appropriate joint. The contour of the joint sleeve should be standardized and effective. When connecting the head buckle, determine the buckle amount based on the inner diameter and diameter of the hose.