Steel wire braided rubber hose is very common and is a commonly used pipeline in hydraulic systems. It is made of synthetic rubber and reinforced with steel wire layers. The outer layer is oil and weather resistant leather with adhesive between the layers. The installation location should avoid heat sources as much as possible. If necessary, waterproof sleeves or insulation materials can be installed. Protective measures should be taken at the intersection or friction with the surface of mechanical equipment to prevent the hose from cracking due to damage.

Installation method of rubber hose assembly:

1. When using a steel wire braided rubber hose in a short space with a relatively small bending radius, the desired effect can be achieved by using a 90 degree elbow or other joint to avoid excessive bending of the hose.

2. Do not twist during installation, as twisting the hose will reduce the compressive strength of the joint and cause it to loosen.

3. When the rubber hose is compressed during operation, its length will change, and it will become longer under high-pressure operation, so there is usually a slight error. After completion, do not add fixing devices at the bend to allow the hose to move. If it is fixed, it is easy to come into contact with the fixed object, causing wear and damage.

4. When in working condition, do not touch anything to avoid friction. If it is necessary to protect the rubber hose in certain situations, please use a spring sleeve or protective sleeve.

5. In order to avoid pipeline damage and flow limitations, the bending radius of the rubber hose should be increased as much as possible in the budget.

6. During installation, it should be prevented from being in a taut state and appropriate length and capacity should be left to keep the hose loose.

The temperature of the material conveyed by the steel wire braided rubber hose shall not exceed the original factory regulations, and it shall be kept clean and tidy inside. Prevent foreign objects from entering the inferior vena cava, blocking fluid dynamics delivery, and damaging mechanical equipment. During use, it is also necessary to perform upgrade inspection and replacement. If leaks, cracks, detachment, joint rust, stainless steel wire breakage, adhesive brittleness, etc. are found, they should be replaced immediately.