High-pressure steel wire braided hoseThe application in social and economic development is becoming increasingly widespread, especially in the processing and manufacturing fields such as stainless steel, crude oil, and chemical plants. It is precisely because of this that the problem of pulling out should be avoided throughout the entire use process, and some preventive measures have been thought of in advance based on various factors. Now let's explain what to do after the hose breaks?

1. Innovative development mode

Saw off the broken rubber hose, find a high-pressure steel wire braided rubber hose that can withstand working pressure and has a length similar to the broken length, saw off the joint, and connect the electrical connection of the broken rubber hose joint to the replaced steel wire rubber hose.

2. Binding method

Apply construction machinery adhesive to the crack and surround it with 2-3 layers of corrosion-resistant adhesive, with a width of 2-3 times the length of the crack location. Each layer should be coated with glue, and the surrounding corrosion-resistant rubber should be tied together with thin wire and allowed to solidify. If it breaks, it can only be replaced and cannot be restored unless it can be restored by welding in the welding area. If there is a gap in the waveform, it can only be replaced.

Although rubber hoses can be compressed or stretched, if installed in the wrong position, their service life will be reduced. Rubber hoses can be installed horizontally, vertically, or diagonally. Ideally, they should be installed vertically, while avoiding installation near the wheels. If necessary, baffles can be added. Generally, rubber hoses can be divided into three lengths: compression length, which refers to the length of the hose when it is compressed to its maximum position; The second is the installation length, which is the length at the middle position of half the maximum displacement; The third is the stretching length, which refers to the length of the hose when it is stretched to its limit.

The rubber hose should be in the middle position during installation, which is the so-called installation length. When installed in such a position, the high-pressure steel wire braided rubber hose can move in two directions when subjected to axial loads. Otherwise, if it can only move in one direction, it will affect the strength of the hose and reduce its service life. In the actual installation process, considering that measuring the length of the hose with a ruler based on the calculation results before installation may affect installation efficiency, some foreign manufacturers directly install the ruler on the hose and cut it off after installation.